Good day all. Hoping someone can help. Installed a custom gauge package and when pulling the needles off the pin and needle came off the gas gauge. Put back on and seemed to do the sweep When starting but ran it low on gas and the needle seems to gotten stuck on the bottom 8th of the tank reading. Pulled it apart again and when I removed the has gauge needle off just the needle cam off. Didn't push it on as far and now the gauge only sweeps 3/4 of the way up. It is full of gas right now and only reads 3/4 of a way up. Any one have any ideas on what I can do to get it reading properly. Thanks in advance.